An explosion-proof lamp performance: 

 / Explosion-proof lighting, inflammable and explosive dangerous place in safe and reliable operation. 

 / MH high-efficiency gas discharge lamp as the light source, high luminous efficiency, the average life of 10,000 hours or more. 

 / Light body with light alloy, high strength, corrosion resistance, impact resistance; transparent pieces of special glass with large arc temperature, expanding the space for heat dissipation, reducing the temperature rise and increase bulb life. 

 / Light surface coating using the latest technology, no color, no rust, can prevent water and rain, but also long-term use outdoors. 

 / Small size, light weight, can be boom-type, wall, ceiling and pole-type and other installation, simple operation. 

 Two explosion-proof lights use: 

 1, to determine the location of the installation of lamps and ballasts, select the appropriate installation, and have the appropriate length of the special three-core cable. 
 2, lamps and ballasts with screws fixed installation, and then the lights M6 Allen wrench loosen the screws around the cover, opened the lamp cover. 
 3, with a screwdriver to remove the bulb base mounting screws and prepared three-core cable end through the introduction of devices into Light compression nut cavity for wiring; red and blue wire to the lamp, the yellow wire to the ground online; connected line, the lamp base screws tighten on, the lamp cover is closed, then around the lamp cover screws tightened. 
 4, the three-core cable the other end of the introduction through ballast output devices, corresponding to the receiving terminal of the ballast within the marked terminals. 
 5, the power cable to be connected at one end by the introduction of ballast input device to the input terminal, and then the ballast surface cover closed and tighten the screws, then the other end of cable according to anti- explosion ask to be connected to 220V power lighting. 

 Warning: 
 1, non-charged open lamps. 
 2, non-professionals are not free installation and removal of lamps and ballasts. 

 Three explosion-proof lights Note: 

 1, the company must be used with a special ballast. 
 2, installation and maintenance of lamps, it must first cut off the power. 
 3, transparent pieces of center temperature is higher, do not touch. 
 4, replace the lamp, you should use the same types of light bulbs; if the model or the power to change the light bulbs, ballasts should be replaced accordingly. 
 5, lamp starting current is 2.5 times the normal operating current, 150W lamp starting current of 1.7A, 35W lamp starting current of 0.4A. 

 Four explosion-proof light technical parameters: 

 BFC8120 Rated voltage: 220VAC 

 BFC8120 type of light source: MH HID 

 BFC8120 Protection: IP65 

 BFC8120 Dimensions: 375 × 264 × 167mm 

 BFC8120 Weight: 3.5kg