Applications: 

 BFC8920 dust explosion-proof light-field light: for explosive and flammable dust environment for fixed lighting. 


 Performance: 

 / Dust explosion-proof lamps, can be explosive and flammable dust in the environment safe and reliable operation. 

 / High-intensity gas discharge lamp as the light source, long life, high luminous efficiency, through the fog of good, uniform illumination. 

 / Excellent electromagnetic compatibility, electromagnetic interference and does not produce pollution. 

 / Light body with light alloy, high strength, corrosion resistance, impact resistance; transparent pieces of special glass with large arc temperature, expanding the space for heat dissipation, reduce temperature, improve the life of the lamp. 

 / Lamp shell surface using the latest spray technology, no color, no rust, the overall protection grade IP65, long-term corrosion resistance in outdoor environments and a variety of reliable use. 

 / Small size, light weight, can be ceiling, boom-type and other installation, easy to install. 

 Note: 

 1, the company must be used with a special ballast. 
 2, installation and maintenance of lamps, turn off the power. 
 3, when used, has some light surface temperature is normal, transparent pieces of center temperature is higher, not touch. 
 4, replace the lamp, you should use the same types of light bulbs. 
 5, lamp starting current is 2.5 times the normal operating current, 150W lamp starting current of 1.7A. 

 Technical parameters: 

 Rated voltage: 220VAC 50Hz 

 Housing protection: IP65 

 Inlet thread: G3 / 4 

 The introduction of cable: φ8 ~ φ14mm 

 Dimensions: 375 × 264 × 167mm 

 Total weight: 3.5Kg 

 Use: 

 1, to determine the location of the installation of lamps and ballasts, select the appropriate installation, and have the appropriate length of the special three-core cable. 
 2, lamps and ballasts with screws fixed installation, and then the lights M6 Allen wrench loosen the screws around the cover, opened the lamp cover. 
 3, with a screwdriver to remove the bulb base mounting screws and prepared three-core cable end through the introduction of devices into Light compression nut cavity for wiring; red and blue wire to the lamp, the yellow wire to the ground online; connected line, the lamp base screws tighten on, the lamp cover is closed, then around the lamp cover screws tightened. 
 4, the three-core cable the other end of the introduction through ballast output devices, corresponding to the receiving terminal of the ballast within the marked terminals. 
 5, the power cable to be connected at one end by the introduction of ballast input device to the input terminal, and then the ballast surface cover closed and tighten the screws, then the other end of cable according to anti- explosion ask to be connected to 220V power lighting. 

 Warning: 

 1, non-charged open lamps. 
 2, non-professionals are not free installation and removal of lamps and ballasts.